Primary Command RESULTS

  FEMVIEW Command only.

The RESULTS command allows the details of the results required for inspection to be specified. It is also the command used to perform calculations on results, to scan results, and to combine and factor loadcases.

The RESULTS command is only available within the results assessment module FEMVIEW and has the following secondary commands:

2.15.1 RESULTS CALCULATE - calculate results

2.15.2 RESULTS ELEMENT - select element results attribute

2.15.3 RESULTS GAUSSIAN - select Gaussian results attribute

2.15.4 RESULTS INVARIANT - select element constant results attribute

2.15.5 RESULTS LOADCASE - select loadcase(s)

2.15.6 RESULTS NODAL - select nodal results attribute

2.15.7 RESULTS OFF - switch off results presentation

2.15.8 RESULTS RANGE - specify results range controls

2.15.9 RESULTS STACK - select many results

2.15.10 RESULTS TRANSFORM - transform results