CONSTRUCT COORDSYS GLOBAL

  

This command is used to return to the global system.

Point coordinates may be defined in the global, or a local coordinate system (see command CONSTRUCT COORDSYS LOCAL). The global system is the default. When point coordinates have been entered in a local coordinate system, the CONSTRUCT COORDSYS GLOBAL command may be used to exit this mode and return to the global system.

The current coordinate system is shown by the UTILITY TABULATE GEOMETRY STATUS command (if no coordinate system is given then the global system is current).

See also the following commands

'CONSTRUCT COORDSYS LOCAL'
'UTILITY TABULATE GEOMETRY STATUS'