PROPERTY LOADS TEMPERAT [lname] [lnumb] part [opart] temp tdiff

        

This command is used to apply temperatures on nodes.

lname = name of the loadcase, used at later references.

lnumb = loadcase number (integer, default=1).

part = part that shall have specified temperature, line, surface, body or set.

opart = optional part of next higher order from loaded part, which contains the elements to be loaded. Only required when there is ambiguity over which elements are to be loaded. See note 1.

temp = temperature.

tdiff = temperature difference

Notes:

1.

Ambiguity over which elements are loaded will only arise when the part that is loaded is attached to more than one other part, (for example where a load is applied to a line which is attached to two surfaces). Any ambiguity about which elements will be loaded can be resolved by specifying the part containing the elements to be loaded in the definition of the load.
The command is restricted to only allow certain combinations of parts i.e. point/line, line/surface and surface/body. In the case of sets, a similar relationship is required between the parts in the set.
If the load is to be applied to several of the parts sharing the loaded part, the command should be repeated for each part containing elements.
If the second (optional) part is not given then the load is applied to the part with the lower entity number.

Examples:

1.

PROPERTY LOADS TEMPERAT LO6 SU2A 243 47

Define a temperature load called LO6 of 243 on SU2A with a temperature difference of 47. The units depend on the analysis package.

See also the following commands

'LABEL GEOMETRY LOADS'
'LABEL MESH LOADS'
'UTILITY DELETE LOADS'
'UTILITY TABULATE GEOMETRY LOADS'