Next: GEOMETRY LINE ELEMENTS lnam [elty] Up: GEOMETRY LINE Control Previous: GEOMETRY LINE CIRCLE pnam radius [plane]
Next: GEOMETRY LINE ELEMENTS lnam [elty]
Up: GEOMETRY LINE Control
Previous: GEOMETRY LINE CIRCLE pnam radius [plane]
| lnam | = | name of the line to be created. |
| pnam1 | = | start point of line. |
| pnam2 | = | end point of line. |
| shape | = | Underlying FEMGEN shape for the NURB curve. |
| divn | = | Number of divisions on the line. If not specified the default is used. |
| parm1 | = | Parametric position of the start point of the line on the NURB curve. |
| parm2 | = | Parametric position of the end point of the line on the NURB curve. |
| parm3 | = | Value used (when there are two possible parts of an curve) to indicate |
| which part of the curve is to be used. |
This command allows a line to be defined using all or part of a NURB curve as its underlying shape. This command is primarily provided to support the archiving of entities created via the CAD interfaces.
If the parametric positions of the start and end points are not given then FEMGEN will calculate the values.
See also the following commands
'CONSTRUCT SHAPE CURVE NURB'
'CONSTRUCT SHAPE SURFACE NURB'
'LABEL GEOMETRY LINES'
'UTILITY DELETE LINES'
'UTILITY TABULATE GEOMETRY LINES'
'VIEW GEOMETRY'
Femsys Limited