3.14 DIEGH

3.14 DIEGH

Calling sequence : CALL DIEGH (IDENUM, IETYPE, IGROUP, IRECVR, NGAUSS, NSURFS, ISYSTM, IGSYST, IEXIT, IUNT)

Purpose : To enter an element at Gauss points, element results header for a single element.

Parameters :

	In
	IDENUM	Element identification number (Integer)
	IETYPE	FEMVIEW element type number (Integer)
	IGROUP	Element group number (Integer)
	IRECVR	Record variant identification number (Integer)
	NGAUSS	Number of Gauss points for which results are to be entered (Int)
	NSURFS	Number of surfaces for which results are to be entered (Integer)
	ISYSTM	Axis system indicator (Integer)

0 Results are expressed in the global system

1 Results are expressed in an element Gaussian local axis system

IGSYST	Not currently used (set to zero internally) (Integer)
IUNT		Temporary file channel number (Integer)
Out
IEXIT		Error condition

Use : This routine is used to enter an element at Gauss points header record. For each element; routine DIEGH is called once only, and routine DIEGR is called once for each Gauss point at each surface. The number of Gauss points is the inner repeat, and the number of surfaces is the outer repeat when calling routine DIEGR.

The three types of element wise results cannot be mixed within a dataset.

It is not necessary to enter results for every element.

Element results must be entered in the same order as the element topology data was entered.

Errors : The error condition is indicated by the value of IEXIT.

IEXIT

Meaning

0		Successful Call
32		Current error must be cleared up first
129		Error in writing to temporary file on unit (iunt)
141		Id numbers cannot be less than 1
143		Id above 99999 not allowed for 5 digit character file
158		More repeats expected for previous element
165		Results headers have not been completed
166		Cannot enter results, current results type is : (IRTYPE)
177		Invalid local axis system indicator
211		Invalid temporary file unit number (iunt)