Primary Command FEMGEN

      

FEMGEN [Model_name]

In order to create or to modify geometry it is necessary to issue the command FEMGEN and give either the name of an existing model which is to be modified or the name of a new model which is to be created. This takes the user into the model creation environment. The name that is given has to be 6 characters or less.

When FEMGEN is used under DOS or Windows 3.*, modelnames `CON' and `LPT' should not be used as these are reserved system names.

Examples:

1.

FEMGEN

The current model will be used in FEMGEN. If no model is current the user will be prompted for a model name which must be 6 characters or less.

2.

FEMGEN CONROD

The model CONROD will be used in FEMGEN. If no model CONROD exists, then it is assumed that the user wishes to create a new model called CONROD.